从套接字选择中跳出

织梦狗教程 C/C++问题

2021-01-01

breaking out from socket select(从套接字选择中跳出)

本文介绍了从套接字选择中跳出的处理方法，对大家解决问题具有一定的参考价值，需要的朋友们下面随着小编来一起学习吧！

问题描述

我有一个循环，它基本上每隔几秒(超时后)调用一次:

I have a loop which basically calls this every few seconds (after the timeout):

 while(true){

    if(finished)
       return;

    switch(select(FD_SETSIZE, &readfds, 0, 0, &tv)){
        case SOCKET_ERROR : report bad stuff etc; return;
        default : break;
    }

    // do stuff with the incoming connection
 }

所以基本上每隔几秒钟(由电视指定)，它就会重新激活聆听.

So basically for every few seconds (which is specified by tv), it reactivates the listening.

这是在线程 B(不是主线程)上运行的.有时我想从线程 A(主线程)立即结束这个接受器循环，但似乎我必须等到时间间隔结束..

This is run on thread B (not a main thread). There are times when I want to end this acceptor loop immediately from thread A (main thread), but seems like I have to wait until the time interval finishes..

有没有办法从另一个线程中断 select 函数，以便线程 B 可以立即退出?

Is there a way to disrupt the select function from another thread so thread B can quit instantly?

推荐答案

最简单的方法大概是使用 pipe(2) 创建一个管道并将读取端添加到 readfds.当另一个线程想要中断 select() 时，只需向它写入一个字节，然后再消费它.


The easiest way is probably to use pipe(2) to create a pipe and add the read end to readfds. When the other thread wants to interrupt the select() just write a byte to it, then consume it afterward.

                        这篇关于从套接字选择中跳出的文章就介绍到这了，希望我们推荐的答案对大家有所帮助，也希望大家多多支持编程学习网！